97/161/EC: Commission Decision of 17 February 1997 on the procedure for attesting the conformity of construction products pursuant to Article 20 (2) of Council Directive 89/106/EEC as regards metal anchors for use in concrete for fixing lightweight systems (Text with EEA relevance)
Data as of 2026-07-04 · Compiled from an official source version. Later amendments or repeals may not be reflected; the official text prevails. · Read the official text ↗
The products set out in Annex I shall have their conformity attested by a procedure whereby, in addition to a factory production control system operated by the manufacturer, an approved certification body is involved in assessment and surveillance of the production control or of the product itself.
The procedure for attesting conformity as set out in Annex II shall be indicated in mandates for guidelines for European technical approvals.
This Decision is addressed to the Member States. Done at Brussels, 17 February 1997. For the Commission Martin BANGEMANN Member of the Commission (1) OJ No L 40, 11. 2. 1989, p. 12. (2) OJ No L 220, 30. 8. 1993, p. 1.
Metal anchors for use in concrete for fixing lightweight systems: for use in redundant systems for fixing and/or supporting to concrete, elements such as lightweight suspended ceilings, as well as installation. ANNEX II PRODUCT FAMILY Metal anchors for use in concrete for fixing lightweight systems (1/1) Systems of attestation of conformity For the product(s) and intended use(s) listed below, European Organization for Technical Approval (EOTA) is requested to specify the following system(s) of attestation of conformity in the relevant Guideline for European Technical Approval: >TABLE> The specification for the system should be such that it can be implemented even where performance does not need to be determined for a certain characteristic, because at least one Member State has no legal requirement at all for such characteristic (see Article 2.1 of Directive 89/106/EEC and, where applicable, clause 1.2.3 of the Interpretative Documents). In those cases the verification of such a characteristic must not be imposed on the manufacturer if he does not wish to declare the performance of the product in that respect.
Source: EUR-Lex (Publications Office of the EU), © European Union, reuse permitted under Commission Decision 2011/833/EU.