Commission Regulation (EU) No 1076/2010 of 22 November 2010 concerning the classification of certain goods in the Combined Nomenclature

• CELEX: Regulation (EU) No 1076/2010
• Articles: 4

Article 1

The goods described in column (1) of the table set out in the Annex shall be classified within the Combined Nomenclature under the CN code indicated in column (2) of that table.

Article 2

Binding tariff information issued by the customs authorities of Member States, which is not in accordance with this Regulation, can continue to be invoked for a period of 3 months pursuant to Article 12(6) of Regulation (EEC) No 2913/92.

Article 3

This Regulation shall enter into force on the 20th day following its publication in the Official Journal of the European Union .

Schedules & Appendices

ANNEX

ANNEX

Description of the goods

Classification

(CN code)

Reasons

(1)

(2)

(3)

An article (so-called ‘common mode choke’) with dimensions of approximately 3 × 3 × 2 cm (including the base plate), consisting of two coils of insulated copper wire wound on a circular ferrite core, with a ratio of 1:1.

The differential mode current (signal), flowing in opposite directions through the coils, creates equal and opposite magnetic fields which cancel each other out. This results in the article presenting zero impedance to the differential mode current, which passes through unaltered.

The common mode current (interference), flowing in the same direction through the coils, creates equal and in-phase magnetic fields which add together. This results in the article presenting high impedance to the common mode current, which passes through attenuated.

8504 50 95

Classification is determined by General Rules 1 and 6 for the interpretation of the Combined Nomenclature and by the wording of CN codes 8504 , 8504 50 and 8504 50 95 .

Classification under subheading 8504 31 as a transformer is excluded, as although the construction of the article is that of a transformer, it cannot transform an alternating current into a different alternating current. It only transfers alternating currents with a ratio of 1:1 (see also the Harmonised System Explanatory Notes to heading 8504 ).

Given its function, the article constitutes an inductor of subheading 8504 50 , as it is used to limit or prevent the flow of common mode current (interference) while leaving the flow of differential mode current (signal) unaltered.

The article is therefore to be classified under CN code 8504 50 95 as an inductor.