Commission Implementing Regulation (EU) No 697/2012 of 25 July 2012 concerning the classification of certain goods in the Combined Nomenclature

• CELEX: Implementing Regulation (EU) No 697/2012
• Articles: 4

Article 1

The goods described in column (1) of the table set out in the Annex shall be classified within the Combined Nomenclature under the CN code indicated in column (2) of that table.

Article 2

Binding tariff information issued by the customs authorities of Member States, which is not in accordance with this Regulation, can continue to be invoked for a period of three months under Article 12(6) of Regulation (EEC) No 2913/92.

Article 3

This Regulation shall enter into force on the twentieth day following that of its publication in the Official Journal of the European Union .

Schedules & Appendices

ANNEX

ANNEX

Description of the goods

Classification

(CN code)

Reasons

(1)

(2)

(3)

An article (so-called ‘transformer module with RJ 45 plug’) with connecting pins in a housing with dimensions of approximately 2 × 1,5 × 1,5 cm.

The article comprises a printed circuit board equipped with four transformers, a capacitor and four resistors. It also incorporates two light emitting diodes which are not connected to the other components.

The article is specifically designed for a 10/100 BASE-T Ethernet network and is for placement onto a printed circuit board for the purposes of connecting machines within a local area network for signal transmission and reception.

It also provides for galvanic separation and protection of signals against over-voltage and common mode noise.

8517 70 90

Classification is determined by General Rules 1 and 6 for the interpretation of the Combined Nomenclature, Note 2(b) to Section XVI and by the wording of CN codes 8517 , 8517 70 and 8517 70 90 .

In addition to the connector, the article contains several different electrical components. Furthermore, it also performs several different electrical functions besides making connections to or in electrical circuits, such as galvanic separation and protection against over-voltage and common mode noise. These components are equally important as all contribute together to the technical requirements necessary for the establishment of a connection over an Ethernet network.

Consequently, classification under heading 8536 as a plug is excluded.

As the article is used in apparatus for communication in a wired network, it is therefore to be classified under CN code 8517 70 90 as a part of apparatus for communication in a wired or wireless network.