Commission Delegated Regulation (EU) 2024/1180 of 14 February 2024 amending Regulation (EU) 2015/758 of the European Parliament and of the Council as regards the standards relating to eCall

• CELEX: Delegated Regulation (EU) 2024/1180
• Articles: 3

Article 1 Amendments to Regulation (EU) 2015/758

In Article 5(8), second subparagraph, of Regulation (EU) 2015/758, points (a) to (d) are replaced by the following:

‘(a)

EN 16072:2022 “Intelligent transport systems – eSafety – Pan-European eCall operating requirements”;

(b)

from 9 May 2024 until 31 December 2025, EN 16062:2023 “Intelligent transport systems – eSafety – eCall High Level Application Requirements (HLAP)”; and from 1 January 2026, CEN/TS 17184:2022 “Intelligent transport systems – eSafety – eCall high level application protocols (HLAP) using IP multimedia subsystem (IMS) over packet-switched networks”;

(c)

from 9 May 2024 until 31 December 2025, EN 16454:2023 “Intelligent transport systems – eSafety – eCall end to end conformance testing”; and from 1 January 2026, CEN/TS 17240:2018 “Intelligent transport systems – eSafety – eCall end to end conformance testing for IMS packet-switched based systems”;

(d)

EN 15722:2020 “Intelligent transport systems – eSafety – eCall minimum set of data (MSD)”;’.

Article 2 Transitional provisions

1.   With effect from 1 January 2025, national authorities shall not refuse to grant new type approvals or extensions for existing approvals for vehicles, systems, components or separate technical units, where those comply with the technical specifications set out in CEN/TS 17184:2022 and CEN/TS 17240:2018, if a manufacturer so requests.

2.   With effect from 1 January 2026, national authorities shall refuse to grant new type approvals or extensions for existing approvals for vehicles, systems, components or separate technical units, where those do not comply with Regulation (EU) 2015/758, as amended by this Regulation.

3.   With effect from 1 January 2027, in the case of new vehicles approved after 31 March 2018 in accordance with Regulation (EU) 2015/758 which do not comply with the technical specifications set out in CEN/TS 17184:2022 and CEN/TS 17240:2018, national authorities shall consider the certificates of conformity to be no longer valid for the purposes of Article 48(1) of Regulation (EU) 2018/858.

Article 3 Entry into force

This Regulation shall enter into force on the twentieth day following that of its publication in the Official Journal of the European Union .