ANNEX ISupplementary provisions
CIRCULATION FIXTURES - Road traffic noise reducing devices and barriers; and - anti-glare screens. ANNEX II CIRCULATION FIXTURES - Road marking products: - permanent marking tapes and preformed markings, - traffic paints, hot applied thermoplastics, cold applied plastics (with or without antiskid aggregates) including premixed glass beads, - traffic paints, hot applied thermoplastics, cold applied plastics (to be used for road marking) put on the market with indications on types and proportions of dropped-on glass beads and/or anti-skid aggregates, - retro-reflecting road studs. - Road traffic signs and traffic control devices installed permanently for vehicular and pedestrian traffic uses: - permanent traffic signs, - traffic bollards, - marker posts, - traffic lights and fixed danger lamps, - permanent warning devices and delineators, - variable message traffic signs. - Road lighting columns. - Vehicle restraint systems: - crash cushions, - transition barriers, - cables, - parapets. - Pedestrian restraint systems including pedestrian bridge parapets. ANNEX III PRODUCT FAMILY CIRCULATION FIXTURES (1/2) Systems of attestation of conformity For the product(s) and intended use(s) listed below, European Committee for Standardization/European Committee for Electrotechnical Standardization (CEN/Cenelec) are requested to specify the following system(s) of attestation of conformity in the relevant harmonized standard(s): >TABLE> The specification for the system should be such that it can be implemented even where performance does not need to be determined for a certain characteristic, because at least one Member State has no legal requirement at all for such characteristic (see Article 2 (1) of Directive 89/106/EEC and, where applicable, clause 1.2.3 of the Interpretative Documents). In those cases the verification of such a characteristic must not be imposed on the manufacturer if he does not wish to declare the performance of the product in that respect. PRODUCT FAMILY CIRCULATION FIXTURES (2/2) Systems of attestation of conformity For the product(s) and intended use(s) listed below, European Committee for Standardization /European Committee for Electrotechnical Standardization (CEN/Cenelec) are requested to specify the following system(s) of attestation of conformity in the relevant harmonized standard(s): >TABLE> The specifications for the system should be such that it can be implemented even where performance does not need to be determined for a certain characteristic, because at least one Member State has no legal requirement at all for such characteristic (see Article 2 (1) of Directive 89/106/EEC and, where applicable, clause 1.2.3 of the Interpretative Documents). In those cases the verification of such a characteristic must not be imposed on the manufacturer if he does not wish to declare the performance of the product in that respect.