ANNEX ISupplementary provisions
AGGREGATES FOR USES WITHOUT HIGH SAFETY REQUIREMENTS Aggregates For concrete, mortar, grout, bituminous mixtures, surface treatments, unbound and hydraulically bound mixtures used for roads and other civil engineering works. Armourstones For uses in hydraulic structures and other civil engineering works. Railway ballast For uses in railway works. Fillers For concrete, mortar, grout, bituminous mixtures and surface treatments used for roads and other civil engineering works. ANNEX II AGGREGATES FOR USES WITH HIGH SAFETY REQUIREMENTS Aggregates For concrete, mortar, grout, bituminous mixtures, surface treatments, unbound and hydraulically bound mixtures used for roads and other civil engineering works. Armourstones For uses in hydraulic structures and other civil engineering works. Railway ballast For uses in railway works. Fillers For concrete, mortar, grout, bituminous mixtures and surface treatments used for roads and other civil engineering works. ANNEX III PRODUCT FAMILY AGGREGATES FOR USES WITHOUT HIGH SAFETY REQUIREMENTS (1/2) 1. Systems of attestation of conformity For the product(s) and intended use(s) listed below, CEN/Cenelec are requested to specify the following system(s) of attestation of conformity in the relevant harmonised standard(s): >TABLE> The specification for the system should be such that it can be implemented even where performance does not need to be determined for a certain characteristic, because at least one Member State has no legal requirement at all for such characteristic (see Article 2(1) of Directive 89/106/EEC and, where applicable, clause 1.2.3 of the interpretative documents). In those cases the verification of such a characteristic must not be imposed on the manufacturer if he does not wish to declare the performance of the product in that respect. PRODUCT FAMILY AGGREGATES FOR USES WITH HIGH SAFETY REQUIREMENTS (2/2) 1. Systems of attestation of conformity For the product(s) and intended use(s) listed below, CEN/Cenelec are requested to specify the following system(s) of attestation of conformity in the relevant harmonised standard(s): >TABLE> The specification for the system should be such that it can be implemented even where performance does not need to be determined for a certain characteristic, because at least one Member State has no legal requirement at all for such characteristic (see Article 2(1) of Directive 89/106/EEC and, where applicable, clause 1.2.3 of the interpretative documents). In those cases the verification of such a characteristic must not be imposed on the manufacturer if he does not wish to declare the performance of the product in that respect.