Formal non-compliance
Article 41
1. Without prejudice to Article 38, where a Member State makes one of the following findings, it shall require the relevant economic operator to put an end to the non-compliance concerned: (a) the CE marking has been affixed in violation of Article 30 of Regulation (EC) No 765/2008 or of Article 19 of this Directive; (b) the CE marking has not been affixed; (c) the identification number of the notified body has been affixed in violation of Article 19 or has not been affixed, where required by Article 19; (d) the EU declaration of conformity has not been drawn up; (e) the EU declaration of conformity has not been drawn up correctly; (f) the technical documentation referred to in Annexe IV, Parts A and B, and Annexes VII, VIII and XI is either not available or not complete; (g) the name, registered trade name or registered trade mark or the address of the installer, manufacturer or importer has not been indicated in compliance with Article 7(6), Article 8(6) or Article 10(3); (h) the information allowing identification of the lift or the safety component for lifts has not been indicated in compliance with Article 7(5) or Article 8(5); (i) the lift or the safety component for lifts is not accompanied by the documents referred to in Article 7(7) or Article 8(7) or those documents are not in compliance with the applicable requirements. 2. Where the non-compliance referred to in paragraph 1 persists, the Member State concerned shall take all appropriate measures to restrict or prohibit the use of the lift or to recall it, or to restrict or prohibit the making available on the market of the safety component for lifts or ensure that it is recalled or withdrawn from the market.