ANNEX VISupplementary provisions
ANNEX VI Information to be provided in the cases where end-users cannot be expected to see the product displayed, except on the internet A. DOMESTIC OVENS 1. The information referred to in Article 4(1)(b) shall be provided in the following order: (a) supplier’s name or trade mark; (b) supplier’s model identifier, i.e. the model identifier of the specific domestic oven to which the figures quoted below apply; (c) the energy efficiency class of the model for each cavity as defined in Annex I, Table 1; the declared class shall not be more favourable than the class reported in the technical documentation in Annex V; (d) the energy consumption per cycle for each cavity if available in conventional mode and in fan-forced convection mode; the measured energy consumption shall be expressed in kWh (electric and gas ovens) and in MJ (gas ovens), rounded to two decimal places; the declared value shall not be lower than the value reported in the technical documentation in Annex V; (e) the number of cavities; the heat source(s) per cavity; the volume of each cavity. 2. Where other information contained in the product information fiche is also provided, it shall be in the form and order specified in Annex IV. 3. The size and font in which all the information referred to in this Annex is printed or shown, shall be legible. B. DOMESTIC RANGE HOODS 1. The information referred to in Article 4(2)(b) shall be provided in the following order: (a) supplier’s name or trade mark; (b) supplier’s model identifier, i.e. the model identifier of the specific range hood to which the figures quoted below apply; (c) the energy efficiency class of the model as defined in Table 2 of Annex I; the declared class shall not be more favourable than the class reported in the technical documentation in Annex V; (d) the annual energy consumption of the model in kWh, as defined in point 2.1 of Annex II; the declared value shall not be lower than the value reported in the technical documentation in Annex V; (e) the fluid dynamic efficiency class of the model as defined in Table 3 of Annex I; the declared class shall not be more favourable than the class reported in the technical documentation in Annex V; (f) the lighting efficiency class of the model as defined in Table 4 of Annex I; the declared class shall not be more favourable than the class reported in the technical documentation in Annex V; (g) the grease filtering efficiency class of the model as defined in Table 5 of Annex I; the declared class shall not be more favourable than the class reported in the technical documentation in Annex V; (h) the airborne acoustical A-weighted sound power emissions (weighted average value – L WA ) of a domestic range hood at minimum and maximum speed available in normal use, in dB rounded to the nearest integer; the declared value shall not be lower than the value reported in the technical documentation in Annex V. 2. Where other information contained in the product information fiche is also provided, it shall be in the form and order specified in Annex IV. 3. The size and font in which all the information referred to in this Annex is printed or shown, shall be legible.