ANNEX ISupplementary provisions
ANNEX I The Annex to Delegated Regulation (EU) 2017/655 is amended as follows: (1) points 2.6.1.1 and 2.6.1.2 are replaced by the following: ‘2.6.1.1. Testing 9 engines with an accumulated service of less than a % of the EDP, in accordance with Table 1. Test results shall be submitted to the approval authority by 31 December 2022. 2.6.1.2. Testing 9 engines with an accumulated service higher than b % of the EDP, in accordance with Table 1. Test reports shall be submitted to the approval authority by 31 December 2024.’; (2) in point 2.6.1.3, the following Table 1 is added: ‘ Table 1 % of EDP values Reference power of selected engine (kW) a b 56 ≤ P < 130 20 55 130 ≤ P ≤ 560 30 70’; (3) point 2.6.2.1 is replaced by the following: ‘2.6.2.1. The test results of the first nine engines shall be submitted not later than 12 months after the first engine was installed in a non-road mobile machinery and not later than 18 months after starting the production of the approved engine type or engine family.’; (4) point 3.1.1 is replaced by the following: ‘3.1.1. The non-road mobile machinery's operator performing the in-service monitoring test may be other than the usual professional one if the manufacturer demonstrates to the approval authority that the designated operator has attained enough skills and training to operate the non-road mobile machine.’; (5) in Appendix 3, in point 4.1, the table is replaced by the following: ‘ Table Tolerances Slope of the regression line, m 0,9 to 1,1 – Recommended Coefficient of determination, r 2 min. 0,90 – Mandatory’; (6) Appendix 5 is amended as follows: (a) the following point 2.1.5 is inserted before Figure 1: ‘2.1.5. The reference work and reference CO 2 mass of an engine type, or for all engine types within the same engine family, shall be those specified in points 11.3.1 and 11.3.2 of the addendum to the EU type approval certificate of the engine type or the engine family, as set out in Annex IV to Commission Implementing Regulation (EU) 2017/656 ( *1 ) . ( *1 ) Commission Implementing Regulation (EU) 2017/656 of 19 December 2016 laying down the administrative requirements relating to emission limits and type-approval of internal combustion engines for non-road mobile machinery in accordance with Regulation (EU) 2016/1628 of the European Parliament and of the Council ( OJ L 102, 13.4.2017, p. 364 ).’;" (b) point 3 is replaced by the following: ‘3. Rounding of gaseous pollutant emissions calculations In accordance with Standard ASTM E 29-06b (Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications), the final test results shall be rounded in one step to the number of places to the right of the decimal point indicated by the applicable exhaust emissions limit values set out in Article 18(2) of Regulation (EU) 2016/1628 plus one additional significant figure.’. ( *1 ) Commission Implementing Regulation (EU) 2017/656 of 19 December 2016 laying down the administrative requirements relating to emission limits and type-approval of internal combustion engines for non-road mobile machinery in accordance with Regulation (EU) 2016/1628 of the European Parliament and of the Council ( OJ L 102, 13.4.2017, p. 364 ).’;’