ANNEX IISupplementary provisions
ANNEX II MONITORING AND REPORTING OF EMISSIONS FROM NEW PASSENGER CARS PART A Collection of data on new passenger cars and determination of CO 2 emissions monitoring information 1. Member States shall, for each calendar year, record the following detailed data for each new passenger car registered as an M 1 vehicle in their territory: (a) the manufacturer; (b) the type-approval number and its extension; (c) the type, variant, and version (where applicable); (d) make and commercial name; (e) category of vehicle type-approved; (f) total number of new registrations; (g) mass in running order; (h) the specific emissions of CO 2 (NEDC and WLTP); (i) footprint: the wheel base, the track width of the steered axle and the track width other axle; (j) the fuel type and fuel mode; (k) engine capacity; (l) electric energy consumption; (m) code for the innovative technology or group of innovative technologies and the CO 2 emissions reduction due to that technology (NEDC and WLTP); (n) maximum net power; (o) vehicle identification number; (p) WLTP test mass; (q) deviation and verification factors referred to in point 3.2.8 of Annex I to Implementing Regulation (EU) 2017/1153; (r) category of vehicle registered; (s) vehicle family identification number; (t) electric range, where applicable. Member States shall make available to the Commission, in accordance with Article 7, all data listed in this point, in the format as specified in Section 2 of Part B. 2. The detailed data referred to in point 1 shall be taken from the certificate of conformity of the relevant passenger car. In the case of bi-fuelled vehicles (petrol/gas), the certificates of conformity of which bear specific emissions of CO 2 values for both types of fuel, Member States shall use only the value measured for gas. 3. Member States shall, for each calendar year, determine: (a) the total number of new registrations of new passenger cars subject to EC type-approval; (b) the total number of new registrations of new individually approved passenger cars; (c) the total number of new registrations of new passenger cars subject to national type-approval of small series. PART B Format for the transmission of data For each year, Member States shall report the information specified in points 1 and 3 of Part A in the following formats: SECTION 1 AGGREGATED MONITORING DATA Member State ( 1 ) Year Total number of new registrations of new passenger cars subject to EC type-approval Total number of new registrations of new individually approved passenger cars Total number of new registrations of new passenger cars subject to national type-approval of small series SECTION 2 DETAILED MONITORING DATA — ONE VEHICLE RECORD Reference to point 1 of Part A Detailed data per vehicle registered (a) Manufacturer name EU standard denomination Manufacturer name OEM declaration Manufacturer name in Member State registry ( 2 ) (b) Type-approval number and its extension (c) Type Variant Version (d) Make and commercial name (e) Category of vehicle type-approved (f) Total number of new registrations (g) Mass in running order (h) Specific emissions of CO 2 (combined) NEDC value until 31 December 2020 except for vehicles that fall within the scope of Article 5 for which the NEDC value shall be determined until 31 December 2022 in accordance with Article 5 of Implementing Regulation (EU) 2017/1153 Specific emissions of CO 2 (combined) WLTP value (i) Wheel base Track width steered axle (Axle 1) Track width other axle (Axle 2) (j) Fuel type Fuel mode (k) Engine capacity (cm3) (l) Electric energy consumption (Wh/km) (m) Code of the eco-innovation(s) Total NEDC CO 2 emissions savings due to the eco-innovation(s) until 31 December 2020 Total WLTP CO 2 emissions savings due to the eco-innovation(s) (n) Maximum net power (o) Vehicle identification number (p) WLTP test mass (q) Deviation factor De (where available) Verification factor (where available) (r) Category of vehicle registered (s) Vehicle family identification number (t) Electric range, where available ( 1 ) ISO 3166 alpha-2 codes with the exception of Greece and the United Kingdom for which the codes are ‘EL’ and ‘UK’, respectively. ( 2 ) In the case of national type-approval of small series (NSS) or individual approval (IVA), the manufacturer's name shall be provided in the column ‘Manufacturer name in Member State registry’ whilst in the column ‘Manufacturer name EU standard denomination’ either of the following shall be indicated: ‘AA-NSS’ or ‘AA-IVA’, as the case may be.