ANNEX IISupplementary provisions
ANNEX II Annex II is amended as follows: (1) point 1.1.1, sub point (c) is replaced by the following: ‘(c) verify by means of comparing cryptographic hashes that the input files of components, separate technical units, systems or if applicable their respective families, which are used for the simulation corresponds to the input data of the component, separate technical unit, system or if applicable their respective family for which the certification has been granted’; (2) point 2.1 is amended as follows: (a) in the second paragraph, point (b) is replaced by the following: ‘(b) that the processes used during the demonstration are applied in the same manner in all the production facilities manufacturing vehicles belonging to the application case concerned’; (b) the third paragraph is replaced by the following: ‘For the purpose of the second paragraph, point (a), the verification shall include determination of the CO 2 emissions and fuel consumption of at least one vehicle from each production facility for which the licence has been applied for.’; (3) in Appendix 1, SECTION I is amended as follows: (a) point 1 is replaced by the following: ‘1. Name and address of vehicle manufacturer:’; (b) point 3 is replaced by the following: ‘3. Application case covered:’; (4) in Appendix 2, SECTION I, points 0.1, 0.2 and 0.3 are replaced by the following: ‘0.1 Name and address of vehicle manufacturer: 0.2 Production facilities and/or assembly plants for which the processes referred to in point 1 of Annex II to Commission Regulation (EU) 2017/2400 ( *1 ) have been set up with a view to the operation of the simulation tool 0.3 Application case covered: ( *1 ) OJ L 349, 29.12.2017, p. 1 .’ " ( *1 ) OJ L 349, 29.12.2017, p. 1 .’ ’