ANNEX II附則
ANNEX II Annexes I, II, IV and V to Directive 98/70/EC are amended as follows: (1) Annex I is amended as follows: (a) footnote 1 is replaced by the following: ‘ (1) Test methods shall be those specified in EN 228:2012+A1:2017. Member States may adopt the analytical method specified in replacement EN 228:2012+A1:2017 standard if it can be shown to give at least the same accuracy and at least the same level of precision as the analytical method it replaces.’; (b) footnote 2 is replaced by the following: ‘ (2) the values quoted in the specification are “true values”. In the establishment of their limit values, the terms of EN ISO 4259-1:2017/A1:2021 “Petroleum and related products – Precision of measurement methods and results – Part 1: Determination of precision data in relation to methods of test” have been applied and in fixing a minimum value, a minimum difference of 2R above zero has been taken into account (R = reproducibility). The results of individual measurements shall be interpreted on the basis of the criteria described in EN ISO 4259-2:2017/A1:2019.’; (c) footnote 6 is replaced by the following: ‘ (6) Other mono-alcohols and ethers with a final boiling point no higher than that stated in EN 228:2012 +A1:2017.’; (2) Annex II is amended as follows: (a) in the last line of the table, ‘FAME content – EN 14078’, the entry in the last column ‘Limits’‘Maximum’, ‘7,0’ is replaced by ’10,0’; (b) footnote 1 is replaced by the following: ‘ (1) Test methods shall be those specified in EN 590:2013+A1:2017. Member States may adopt the analytical method specified in replacement EN 590:2013+A1:2017 standard if it can be shown to give at least the same accuracy and at least the same level of precision as the analytical method it replaces.’; (c) footnote 2 is replaced by the following: ‘ (2) The values quoted in the specification are “true values”. In the establishment of their limit values, the terms of EN ISO 4259-1:2017/A1:2021 ‘Petroleum and related products – Precision or measurement methods and results – Part 1: Determination of precision data in relation to methods of test’ have been applied and in fixing a minimum value, a minimum difference of 2R above zero has been taken into account (R = reproducibility). The results of individual measurements shall be interpreted on the basis of the criteria described in EN ISO 4259-2:2017/A1:2019.’; (3) Annexes IV and V are deleted.