ANNEX IISupplementary provisions
ANNEX II Annex V to Regulation (EU) No 305/2011 is amended as follows: (1) point 1 is amended as follows: (a) the following point 1.4a. System 3+ is inserted: ‘1.4a. System 3+ (a) The manufacturer shall carry out: (i) the assessment of the performance of the product on the basis of data collection for input values, assumptions and modelling; (ii) factory production control. (b) The notified assessment validation body shall decide on the issuing, restriction, suspension or withdrawal of the validation report of constancy of performance of the construction product on the basis of the outcome of the following assessments and verifications carried out by that body: (i) validation of the input values, assumptions made and compliance with applicable generic or product category specific rules; (ii) validation of the manufacturer’s assessment; (iii) validation of the process applied to generate that assessment; (iv) validation of the correct usage of software appropriate for the assessment; (v) initial inspection of the manufacturing plant to validate any company-specific data.’; (b) point 1.6. is replaced by the following: ‘1.6. Construction products for which a European Technical Assessment has been issued Notified bodies undertaking tasks under Systems 1+, 1, 3 and 3+ as well as manufacturers undertaking tasks under Systems 2+ and 4 shall consider the European Technical Assessment issued for the construction product in question as the assessment of the performance of that product. Notified bodies and manufacturers shall therefore not undertake the tasks referred to in points 1.1.(b)(i), 1.2.(b)(i), 1.3.(a)(i), 1.4.(b), 1.4a.(a)(i) and 1.5.(a)(i) respectively.’; (2) in point 2, the following point (4) is added: ‘(4) assessment validation body: a body notified, in accordance with Chapter VII, to validate the assessment of the performance of construction products.’; (3) in point 3, the following point 6 is added: ‘6. Environmental sustainability.’.