ANNEX IISupplementary provisions
ANNEX II Annex II (Part-145) to Regulation (EU) No 1321/2014 is amended as follows: (1) in point (h)(2) of point 145.A.30, point (ii) is replaced by the following: ‘(ii) appropriate aircraft-rated certifying staff, qualified in category C or L5, as applicable, and assisted by support staff, as set out in point 145.A.35(a)(1).’; (2) in Appendix II, points (l) and (m) are replaced by the following: ‘(l) Table CLASS RATING LIMITATION BASE LINE AIRCRAFT A1 Aeroplanes above 5 700 kg maximum take-off mass (MTOM) [Shall state the aeroplane manufacturer or the group or series or type and/or the maintenance tasks] Example: Airbus A320 Series [YES/NO] ( *1 ) [YES/NO] ( *1 ) A2 Aeroplanes of 5 700 kg MTOM and below [Shall state the aeroplane manufacturer or the group or series or type and/or the maintenance tasks] Example: DHC-6 Twin Otter Series State whether the issuing of airworthiness review certificates is authorised (only possible for aircraft covered by Annex Vb (Part-ML)) [YES/NO] ( *1 ) [YES/NO] ( *1 ) A3 Helicopters [Shall state the helicopter manufacturer or the group or series or type and/or the maintenance task(s)] Example: Robinson R44 State whether the issuing of airworthiness review certificates is authorised (only possible for aircraft covered by Annex Vb (Part-ML)) [YES/NO] ( *1 ) [YES/NO] ( *1 ) A4 Aircraft other than A1, A2 and A3 aircraft [Shall state the aircraft category (sailplane, balloon, airship, etc.) when applicable, the manufacturer or group or series or type and/or the maintenance task(s)] State whether the issuing of airworthiness review certificates is authorised (only possible for aircraft covered by Annex Vb (Part-ML)) [YES/NO] ( *1 ) [YES/NO] ( *1 ) ENGINES B1 Turbine [Shall state the engine series or type and/or the maintenance task(s)] Example: PT6A Series B2 Piston [Shall state the engine manufacturer or group or series or type and/or the maintenance task(s)] B3 APU [Shall state the engine manufacturer or series or type and/or the maintenance task(s)] B4 Engines other than B1, B2 and B3 [Shall state the engine manufacturer or group or series or type and/or the maintenance task(s)] COMPONENTS OTHER THAN COMPLETE ENGINES OR APUs C1 Air Cond & Press [Shall state the aircraft type or aircraft manufacturer or component manufacturer or the particular component and/or cross-refer to a capability list in the exposition and/or the maintenance task(s)] Example: PT6A Fuel Control C2 Auto Flight C3 Comms and Nav C4 Doors – Hatches C5 Electrical Power & Lights C6 Equipment C7 Engine – APU C8 Flight Controls C9 Fuel C10 Rotorcraft – Rotors C11 Rotorcraft – Trans C12 Hydraulic Power C13 Indicating – recording system C14 Landing Gear C15 Oxygen C16 Propellers C17 Pneumatic & Vacuum C18 Protection ice/rain/fire C19 Windows C20 Structural C21 Water ballast C22 Propulsion Augmentation C23 Other SPECIALISED SERVICES D1 Non-Destructive Testing [Shall state particular NDT method(s)] (m) A maintenance organisation which employs only one person to both plan and carry out all its maintenance activities can only hold limited terms of approval. The maximum permissible limits are as follows: CLASS RATING LIMITATION AIRCRAFT A2 AEROPLANES of 5 700 KG MTOM OR LESS WITH PISTON ENGINE or ELECTRIC POWER PLANT WITH NO FUEL CELL AIRCRAFT A3 HELICOPTERS of 3 175 KG MTOM OR LESS WITH SINGLE-PISTON ENGINE or ELECTRIC POWER PLANT WITH NO FUEL CELL AIRCRAFT A4 SAILPLANES, BALLOONS, AIRSHIPS AND ANY AIRCRAFT of 3 175 KG MTOM OR LESS WITH SINGLE-PISTON ENGINE or ELECTRIC POWER PLANT WITH NO FUEL CELL ENGINES B2 LESS THAN 450 HP ENGINES B4 ELECTRIC ENGINE COMPONENTS OTHER THAN COMPLETE ENGINES OR APUs C1 TO C23 AS PER CAPABILITY LIST SPECIALISED SERVICES D1 NDT NDT METHOD(S) TO BE SPECIFIED It should be noted that such an organisation may be further limited by the competent authority in the terms of approval depending on the capabilities of the particular organisation.’. ( *1 ) – Delete as appropriate