My bookmarksSign up free

Commission Regulation (EC) No 517/2008 CHAPTER II — EC GAUGES

Article 3–Article 5 · 3 articles

Compiled from an official source version. Later amendments or repeals may not be reflected; the official text prevails. · Read the official text ↗

Mesh gauge and twine thickness gauges

Article 3

1.   Community and national inspectors shall use the mesh gauge and twine thickness gauges which comply with the provisions of this Regulation for the determination of the mesh size and the twine thickness of fishing nets when conducting fishery inspections. 2.   The technical specifications applying to the mesh gauge are set out in Annex III. 3.   The technical specifications applying to twine thickness gauges are set out in Annex IV. 4.   The mesh gauge and twine thickness gauges referred to in paragraph 1 shall be marked ‘EC gauge’ and certified by the manufacturer as complying with the technical specification referred in paragraphs 2 and 3 respectively. 5.   The mesh gauge and twine thickness gauges sold or distributed for use by entities or persons other than national fisheries authorities shall not be marked ‘EC gauge’.

Calibration instruments for the mesh gauge

Article 4

The calibrated test weights and calibrated test measuring plate provided for in figure 1 of Annex V shall be certified by the competent national authorities and marked ‘EC’.

Testing of the mesh gauges

Article 5

The accuracy of the mesh gauge shall be verified by: (a) inserting the jaws of the gauge into slots of the calibrated test plate as provided for in figure 1 of Annex V; (b) hanging the calibrated test weights on the fixed jaw, as provided for in figure 2 of Annex V.

Back to Commission Regulation (EC) No 517/2008 — full text

Articles on this page are reproduced verbatim from official open data. See the attribution line.

Source: EUR-Lex (Publications Office of the EU), © European Union, reuse permitted under Commission Decision 2011/833/EU.

What to look at next