1. The employer shall take the measures necessary to ensure that the work equipment made available to workers in the undertaking or establishment is suitable for the work to be carried out or properly adapted for that purpose and may be used by workers without impairment to their safety or health.
In selecting the work equipment which he proposes to use, the employer shall pay attention to the specific working conditions and characteristics and to the hazards which exist in the undertaking or establishment, in particular at the workplace, for the safety and health of the workers, and any additional hazards posed by the use of the work equipment in question.
2. Where it is not possible in this way fully to ensure that work equipment can be used by workers without risk to their safety or health, the employer shall take appropriate measures to minimise the risks.
1. Without prejudice to Article 3, the employer shall obtain and/or use:
(a)
work equipment which, if provided to workers in the undertaking or establishment for the first time after 31 December 1992, complies with:
(i)
the provisions of any relevant Community directive which is applicable;
(ii)
the minimum requirements laid down in Annex I, to the extent that no other Community directive is applicable or is so only partially;
(b)
work equipment which, if already provided to workers in the undertaking or establishment by 31 December 1992, complies with the minimum requirements laid down in Annex I no later than 4 years after that date;
(c)
without prejudice to point (a)(i), and by way of derogation from point (a)(ii) and point (b), specific work equipment subject to the requirements of point 3 of Annex I, which, if already provided to workers in the undertaking or establishment by 5 December 1998, complies with the minimum requirements laid down in Annex I, no later than 4 years after that date.
2. The employer shall take the measures necessary to ensure that, throughout its working life, work equipment is kept, by means of adequate maintenance, at a level such that it complies with point (a) or (b) of paragraph 1 as applicable.
3. Member States shall, after consultation with both sides of industry, and with due allowance for national legislation and/or practice, establish procedures whereby a level of safety may be attained corresponding to the objectives indicated by Annex II.
1. The employer shall ensure that where the safety of work equipment depends on the installation conditions, it shall be subject to an initial inspection (after installation and before first being put into service) and an inspection after assembly at a new site or in a new location by competent persons within the meaning of national laws and/or practices, to ensure that the work equipment has been installed correctly and is operating properly.
2. In order to ensure that health and safety conditions are maintained and that deterioration liable to result in dangerous situations can be detected and remedied in good time, the employer shall ensure that work equipment exposed to conditions causing such deterioration is subject to:
(a)
periodic inspections and, where appropriate, testing by competent persons within the meaning of national laws and/or practices;
(b)
special inspections by competent persons within the meaning of national laws and/or practices each time that exceptional circumstances which are liable to jeopardise the safety of the work equipment have occurred, such as modification work, accidents, natural phenomena or prolonged periods of inactivity.
3. The results of inspections shall be recorded and kept at the disposal of the authorities concerned. They must be kept for a suitable period of time.
When work equipment is used outside the undertaking it shall be accompanied by physical evidence that the last inspection has been carried out.
4. Member States shall determine the conditions under which such inspections are made.
When the use of work equipment is likely to involve a specific risk to the safety or health of workers, the employer shall take the measures necessary to ensure that:
(a)
the use of work equipment is restricted to those persons given the task of using it;
(b)
in the case of repairs, modifications, maintenance or servicing, the workers concerned are specifically designated to carry out such work.
The workplace and position of workers while using work equipment and ergonomic principles shall be taken fully into account by the employer when applying minimum health and safety requirements.
1. Without prejudice to Article 10 of Directive 89/391/EEC, the employer shall take the measures necessary to ensure that workers have at their disposal adequate information and, where appropriate, written instructions on the work equipment used at work.
2. The information and the written instructions shall contain at least adequate safety and health information concerning:
(a)
the conditions of use of work equipment;
(b)
foreseeable abnormal situations;
(c)
the conclusions to be drawn from experience, where appropriate, in using work equipment.
Workers shall be made aware of dangers relevant to them, work equipment present in the work area or site, and any changes affecting them, inasmuch as they affect work equipment situated in their immediate work area or site, even if they do not use such equipment directly.
3. The information and the written instructions shall be comprehensible to the workers concerned.
Without prejudice to Article 12 of Directive 89/391/EEC, the employer shall take the measures necessary to ensure that:
(a)
workers given the task of using work equipment receive adequate training, including training on any risks which such use may entail;
(b)
workers referred to in Article 6(b) receive adequate specific training.
Consultation of workers and workers’ participation
Consultation and participation of workers and/or of their representatives on the matters covered by this Directive, including the Annexes thereto, shall take place in accordance with Article 11 of Directive 89/391/EEC.