Scope
Article 10
Open ↗This Chapter shall apply to the activities set out in Annex I and, where applicable, reaching the capacity thresholds set out in that Annex.
Compiled from an official source version. Later amendments or repeals may not be reflected; the official text prevails. · Read the official text ↗
Scope
This Chapter shall apply to the activities set out in Annex I and, where applicable, reaching the capacity thresholds set out in that Annex.
General principles governing the basic obligations of the operator
Member States shall take the necessary measures to provide that installations are operated in accordance with the following principles: (a) all the appropriate preventive measures are taken against pollution; (b) the best available techniques are applied; (c) no significant pollution is caused; (d) the generation of waste is prevented in accordance with Directive 2008/98/EC; (e) where waste is generated, it is, in order of priority and in accordance with Directive 2008/98/EC, prepared for re-use, recycled, recovered or, where that is technically and economically impossible, it is disposed of while avoiding or reducing any impact on the environment; (f) energy is used efficiently and the use and, where possible, the production of renewable energy is promoted; (fa) material resources and water are used efficiently, including through re-use; (fb) an environmental management system is implemented as provided for in Article 14a; (g) the necessary measures are taken to prevent accidents and limit their consequences; (h) the necessary measures are taken upon definitive cessation of activities to avoid any risk of pollution and return the site of operation to the satisfactory state defined in accordance with Article 22.
Applications for permits
1. Member States shall take the necessary measures to ensure that an application for a permit includes a description of the following: (a) the installation and its activities; (b) the raw and auxiliary materials, other substances, the energy and water used in or generated by the installation; (c) the sources of emissions from the installation, including odours; (d) the conditions of the site of the installation; (e) where applicable, a baseline report in accordance with Article 22(2); (f) the nature and quantities of foreseeable emissions, including odours, from the installation into each medium, as well as an identification of significant effects of the emissions on the environment; (g) the proposed technology and other techniques for preventing or, where this is not possible, reducing emissions from the installation; (h) measures for the prevention, preparation for re-use, recycling and recovery of waste generated by the installation; (i) further measures planned to comply with the general principles of the basic obligations of the operator as provided for in Article 11; (j) measures planned to monitor emissions into the environment; (k) the main alternatives to the proposed technology, techniques and measures studied by the applicant in outline. An application for a permit shall also include a non-technical summary of the details referred to in the first subparagraph. 2. Where information supplied in accordance with the requirements provided for in Directive 85/337/EEC or a safety report prepared in accordance with Directive 96/82/EC or other information produced in response to other legislation fulfils any of the requirements of paragraph 1, that information may be included in, or attached to, the application.
BAT reference documents and exchange of information
1. In order to draw up, review and, where necessary, update BAT reference documents, the Commission shall organise an exchange of information between Member States, the industries concerned, non-governmental organisations promoting human health or environmental protection, the European Chemicals Agency and the Commission. That exchange of information shall aim at an eight-year review cycle of BAT reference documents prioritising the documents that have the highest potential to improve the protection of human health or the environment. The duration of the exchange of information referred to in the first subparagraph shall not exceed four years for each individual BAT reference document. 1a. The Commission shall by 1 July 2026 amend Implementing Decision 2012/119/EU. 2. The exchange of information shall, in particular, address the following: (a) the performance of installations and techniques in terms of emissions, expressed as short- and long-term averages, where appropriate, and the associated reference conditions, consumption and nature of raw materials, water consumption, use of energy and generation of waste; (b) the techniques used, associated monitoring, cross-media effects, economic and technical viability and developments therein; (c) best available techniques and emerging techniques identified after considering the issues mentioned in points (a) and (b). Without prejudice to Union competition law, information considered to be confidential business information or commercially sensitive information shall only be shared with the Commission and, after having signed a confidentiality and non-disclosure agreement, with civil servants and other public employees representing Member States or Union agencies. Information shall be anonymised, in such a manner that it does not refer to a particular operator or installation, when shared with the other stakeholders involved in the exchange of information referred to in paragraph 1. Non-anonymised information may only be shared in cases where anonymising the information would not allow an effective exchange of information on BAT in the context of drawing up, reviewing and, where necessary, updating BAT reference documents, with representatives of non-governmental organisations promoting the protection of human health or the environment and representatives of associations representing the relevant industrial sectors, as appropriate, and where such representatives of organisations and associations have signed a confidentiality and non-disclosure agreement. The exchange of information considered to be confidential business information or commercially sensitive information shall remain strictly limited to what is technically required to draw up, review and, where necessary, update BAT reference documents, and such confidential business information or commercially sensitive information shall not be used for other purposes. 3. The Commission shall establish and regularly convene a forum composed of representatives of Member States, the industries concerned and non-governmental organisations promoting the protection of human health or the environment. The Commission shall obtain the opinion of the forum on the practical arrangements for the exchange of information and, in particular, on the following: (a) the rules of procedure of the forum; (b) the work programme for the exchange of information; (c) guidance on the collection of data; (d) guidance on the drawing up of BAT reference documents, and on their quality assurance including the suitability of their content and format. The guidance referred to in points (c) and (d) of the second subparagraph shall take account of the opinion of the forum and shall be adopted in accordance with the regulatory procedure referred to in Article 75(2). 3a. The Commission shall obtain the opinion of the forum on the method for assessing compliance with emission limit values set out in the permit with regard to emissions to air and water, as set out in Article 15a. 4. The Commission shall obtain and make publicly available the opinion of the forum on the proposed content of the BAT reference documents and shall take into account this opinion for the procedures laid down in paragraph 5. The opinion of the forum referred to in the first subparagraph shall be submitted within six months of the final meeting of the technical working group responsible for that BAT reference document. 5. Decisions on the BAT conclusions shall be adopted in accordance with the regulatory procedure referred to in Article 75(2). 6. After the adoption of a decision in accordance with paragraph 5, the Commission shall make the BAT conclusions and the BAT reference document publicly available without undue delay. 7. Pending the adoption of a relevant decision in accordance with paragraph 5, the conclusions on best available techniques from BAT reference documents adopted by the Commission prior to the date referred to in Article 83 shall apply as BAT conclusions for the purposes of this Chapter except for Article 15(3) and (4).
Permit conditions
1. Member States shall ensure that the permit includes all measures necessary to comply with the requirements of Articles 11 and 18. To that effect, Member States shall ensure that permits are granted further to consultation of all relevant authorities with a responsibility regarding compliance with Union environmental legislation, including with environmental quality standards. Those measures shall include at least the following: (a) emission limit values for polluting substances listed in Annex II to Regulation (EC) No 166/2006, and for other polluting substances, which are likely to be emitted from the installation concerned in significant quantities, having regard to their nature, their hazardousness and their potential to transfer pollution from one medium to another, taking into account the variation of water flow dynamics in receiving water bodies; (aa) environmental performance limit values in accordance with Article 15(4); (ab) appropriate requirements ensuring the assessment of the need to prevent or reduce the emissions of substances fulfilling the criteria of Article 57 or substances addressed in restrictions in Annex XVII to regulation (EC) No 1907/2006; (b) appropriate requirements ensuring protection of the soil, groundwater, surface water and catchment areas for abstraction points of water intended for human consumption as referred to in Article 7 of Directive (EU) 2020/2184, and measures concerning the monitoring and management of waste generated by the installation; (ba) appropriate requirements laying down the characteristics of an environmental management system in accordance with Article 14a; (bb) suitable monitoring requirements for the consumption and reuse of resources such as energy, water and raw materials; (c) suitable emission monitoring requirements specifying: (i) measurement methodology, frequency and evaluation procedure; and (ii) where Article 15(3)(b) is applied, that results of emission monitoring are available for the same periods of time and reference conditions as for the emission levels associated with the best available techniques; (d) an obligation to supply the competent authority regularly, and at least annually, with: (i) information on the basis of results of emission monitoring referred to in point (c) and other required data that enables the competent authority to verify compliance with the permit conditions; and (ii) where Article 15(3)(b) is applied, a summary of the results of emission monitoring which allows a comparison with the emission levels associated with the best available techniques; (iii) information on progress towards fulfilment of the environmental policy objectives referred to in Article 14a; (e) appropriate requirements for the regular maintenance and surveillance of measures taken to prevent emissions to soil, surface and groundwater pursuant to point (b), and appropriate requirements concerning the periodic monitoring of soil, surface and groundwater in relation to relevant hazardous substances likely to be found on site and having regard to the possibility of soil, surface and groundwater contamination at the site of the installation; (f) measures relating to conditions other than normal operating conditions such as start-up and shut-down operations, leaks, malfunctions, momentary stoppages and definitive cessation of operations; (g) provisions on the minimisation of long-distance or transboundary pollution; (h) conditions for assessing compliance with the emission limit values and environmental performance limit values or a reference to the applicable requirements specified elsewhere. 2. For the purpose of paragraph 1(a), emission limit values may be supplemented or replaced by equivalent parameters or technical measures ensuring an equivalent level of environmental protection. 3. BAT conclusions shall be the reference for setting the permit conditions. 4. Without prejudice to Article 18, the competent authority may set stricter permit conditions than those achievable by the use of the best available techniques as described in the BAT conclusions. Member States may establish rules under which the competent authority may set such stricter conditions. 5. Where the competent authority sets permit conditions on the basis of a best available technique not described in any of the relevant BAT conclusions, it shall ensure that: (a) that technique is determined by giving special consideration to the criteria listed in Annex III; and (b) the requirements of Article 15 are complied with. Where the BAT conclusions referred to in the first subparagraph do not contain emission levels associated with the best available techniques, the competent authority shall ensure that the technique referred to in the first subparagraph ensures a level of environmental protection equivalent to the best available techniques described in the BAT conclusions. 6. Where an activity or a type of production process carried out within an installation is not covered by any of the BAT conclusions or where those conclusions do not address all the potential environmental effects of the activity or process, the competent authority shall, after prior consultations with the operator, set the permit conditions on the basis of the best available techniques that it has determined for the activities or processes concerned, by giving special consideration to the criteria listed in Annex III. 7. For installations referred to in point 6.6 of Annex I, paragraphs 1 to 6 of this Article shall apply without prejudice to the legislation relating to animal welfare.
Articles on this page are reproduced verbatim from official open data. See the attribution line.
Source: EUR-Lex (Publications Office of the EU), © European Union, reuse permitted under Commission Decision 2011/833/EU.