My bookmarksSign up free

Regulation (EU) No 167/2013 CHAPTER XI — MAKING AVAILABLE ON THE MARKET, REGISTRATION OR ENTRY INTO SERVICE

Article 38–Article 40 · 3 articles

Compiled from an official source version. Later amendments or repeals may not be reflected; the official text prevails. · Read the official text ↗

Making available on the market, registration or entry into service of vehicles

Article 38

1.   Without prejudice to Articles 41 and 44, vehicles for which EU whole-vehicle type-approval is mandatory or for which the manufacturer has obtained such type-approval under this Regulation shall only be made available on the market, registered or enter into service if they are accompanied by a valid certificate of conformity issued in accordance with Article 33. Where such vehicles are incomplete, making available on the market or entry into service of such vehicles is permitted, but the authorities responsible for vehicle registration of the Member States may refuse to allow the registration and use on the road of such vehicles. 2.   Paragraph 1 shall not apply to vehicles intended for use by the armed services, by civil defence, fire services and forces responsible for maintaining public order or to vehicles approved in accordance with Article 37.

Making available on the market registration or entry into service of end-of-series vehicles

Article 39

1.   Subject to the end-of-series limits and time limit specified in paragraphs 2 and 4, vehicles conforming to a type of vehicle whose EU type-approval has become invalid pursuant to Article 32 may be made available on the market, registered or entered into service. The first subparagraph shall apply only to vehicles within the territory of the Union which were covered by a valid EU type-approval at the time of their production, but which had neither been made available on the market, registered nor entered into service before that EU type-approval lost its validity. 2.   Paragraph 1 shall apply, in the case of complete vehicles, for a period of 24 months from the date on which the EU type-approval became invalid and, in the case of completed vehicles, for a period of 30 months from that date. 3.   A manufacturer who wishes to benefit from paragraph 1 shall submit a request to the national authority of each Member State where the vehicles in question are to be made available on the market, registered or entered into service. That request shall specify any technical or economic reasons preventing those vehicles from complying with the new type-approval requirements. The national authority concerned shall decide, within three months of receiving the request, whether and in what number to permit the registration of those vehicles within their territory. 4.   The amount of end-of-series vehicles shall not exceed 10 % of the number of vehicles registered in the two preceding years or 20 vehicles per Member State, whichever is higher. 5.   A special entry qualifying the vehicle as ‘end-of-series’ shall be made on the certificate of conformity of the vehicles put into service under this procedure. 6.   Member States shall ensure that the number of vehicles to be made available on the market, registered or entered into service under the procedure set out in this Article is effectively monitored. 7.   This Article shall apply only to discontinuation due to termination of validity of the type-approval in the case referred to in point (a) of Article 32(2).

Making available on the market or entry into service of components and separate technical units

Article 40

1.   Components or separate technical units may only be made available on the market or entered into service if they comply with the requirements of the relevant acts listed in Annex I and are properly marked in accordance with Article 34. 2.   Paragraph 1 shall not apply in the case of components or separate technical units which are specifically constructed or designed for new vehicles not covered by this Regulation. 3.   By way of derogation from paragraph 1, Member States may permit the making available on the market or entry into service of components or separate technical units which have been exempted from one or more provisions of this Regulation under Article 35 or are intended for mounting on vehicles covered by approvals granted under Article 37 that concern the component or separate technical unit in question. 4.   By way of derogation from paragraph 1, and unless otherwise provided for in this Regulation or in one of the delegated acts adopted pursuant to this Regulation, Member States may permit the making available on the market or entry into service of components or separate technical units which are intended for mounting on vehicles which, when made available on the market or entered into service, were not required to be type-approved by this Regulation or by Directive 2003/37/EC.

Back to Regulation (EU) No 167/2013 — full text

Articles on this page are reproduced verbatim from official open data. See the attribution line.

Source: EUR-Lex (Publications Office of the EU), © European Union, reuse permitted under Commission Decision 2011/833/EU.

What to look at next