My bookmarksSign up free

Commission Implementing Regulation (EU) 2017/1 CHAPTER 1 — GENERAL PROVISIONS

Article 1–Article 2 · 2 articles

Compiled from an official source version. Later amendments or repeals may not be reflected; the official text prevails. · Read the official text ↗

Subject matter

Article 1

This Regulation lays down rules on watercraft identification, in particular rules on assignment and administration of manufacturer's codes.

Definitions

Article 2

For the purpose of this Regulation, the following definitions shall apply: (a) ‘national body’ means a body appointed by the national authority of each Member State for assigning the unique code of the manufacturer; (b) ‘country where the manufacturer is established’ means the country where the manufacturer has its registered office, in case of a legal person, or a permanent address, in case of a natural person; (c) ‘national register’ means the register of each Member State where the unique code of manufacturer for the manufacturers established in their territory is recorded; (d) ‘third country register’ means the register of the Commission collaborative platform where the unique code of manufacturer for manufacturers established in third countries is recorded; (e) ‘Member States register’ means the compilation of national registers in the Commission collaborative platform; (f) ‘notified bodies' register’ means the register of the Commission collaborative platform where the post-construction assessment identification code is recorded.

Back to Commission Implementing Regulation (EU) 2017/1 — full text

Articles on this page are reproduced verbatim from official open data. See the attribution line.

Source: EUR-Lex (Publications Office of the EU), © European Union, reuse permitted under Commission Decision 2011/833/EU.

What to look at next