Addendum
ANNEX IISupplementary provisions
ANNEX II PART I INFORMATION DOCUMENT FOR EU TYPE-APPROVAL OF MOTOR VEHICLES WITH REGARD TO THEIR DRIVER DROWSINESS AND ATTENTION WARNING SYSTEM Information document No … relating to the EU type-approval of a type of vehicle with regard to the driver drowsiness and attention warning (DDAW) system. The following information shall be supplied in triplicate and include a list of contents. Any drawings or pictures shall be supplied in appropriate scale and in sufficient detail on size A4 or on a folder of A4 format. Photographs, if any, shall show sufficient detail. If the systems, referred to in this information document have electronic controls, information concerning their performance shall be supplied. 0. GENERAL 0.1. Make (trade name of manufacturer): 0.2. Type: 0.2.1. Commercial name(s) (if available): 0.3. Means of identification of type, if marked on the vehicle/component/separate technical unit ( 1 ) : 0.3.1. Location of that marking: 0.4. Category of vehicle: 0.5. Company name and address of manufacturer: 0.8. Name(s) and address(es) of assembly plant(s): 0.9. Name and address of the manufacturer’s representative (if any): 12.11. Driver drowsiness and attention warning (DDAW) system 12.11.2. Detailed description of the DDAW system: 12.11.2.1. Methodology of the DDAW system to assess driver’s drowsiness: 12.11.3. Detailed description of the visual warning of the DDAW system: 12.11.3.1. Reference of the code of the test protocol tested by the Technical Service, for which the DDAW system shall deliver a warning when performed: 12.11.4. Detail description of the technical similarities or the adaptation required to enable the DDAW system: 12.11.5. Means to enable a periodic technical inspection with regard to the DDAW system: PART II EU TYPE-APPROVAL CERTIFICATE (VEHICLE SYSTEM) Communication concerning granting / extension / refusal / withdrawal ( 2 ) of type-approval of a type of vehicle with regard to its driver drowsiness and attention warning (DDAW) system in accordance with the requirements laid down in Commission Delegated Regulation (EU) 2021/1341 ( 3 ) , as last amended by Regulation (EU) No …/… Number of the EU type-approval certificate: Reason for extension / refusal / withdrawal ( 1 ): SECTION I 0.1. Make (trade name of manufacturer): 0.2. Type: 0.2.1. Commercial name(s) (if available): 0.3. Means of identification of type, if marked on the vehicle: 0.3.1. Location of that marking: 0.4. Category of vehicle: 0.5. Name and address of manufacturer: 0.8. Name(s) and address(es) of assembly plant(s): 0.9. Name and address of the manufacturer’s representative (if any): SECTION II 1. Additional information (where applicable): see Addendum. 2. Technical service responsible for carrying out the tests: 3. Date of test report: 4. Number of test report: 5. Remarks (if any): see Addendum. 6. Place: 7. Date: 8. Signature: Addendum to EU type-approval certificate number … 1. Additional information 1.1. Description of the system: 3. Remarks: ( 1 ) Delete where not applicable. ( 2 ) Delete where not applicable. ( 3 ) Commission Delegated Regulation (EU) 2021/1341 of 23 April 2021 supplementing Regulation (EU) 2019/2144 of the European Parliament and of the Council by laying down detailed rules concerning the specific test procedures and technical requirements for the type-approval of motor vehicles with regard to their driver drowsiness and attention warning systems and amending Annex II to that Regulation ( OJ L 292, 16.8.2021, p. 4 , ELI: http://data.europa.eu/eli/reg_del/2021/1341/oj ).