Information requirements for NRVUs as referred to in Article 4(2)
ANNEX VSupplementary provisions
ANNEX V Information requirements for NRVUs as referred to in Article 4(2) 1. From 1 January 2016, the following product information shall be provided: (a) manufacturer's name or trade mark; (b) manufacturer's model identifier, i.e. the code, usually alphanumeric, used to distinguish a specific non-residential ventilation unit model from other models with the same trade mark or supplier's name; (c) declared typology in accordance with Article 2 (RVU or NRVU, UVU or BVU); (d) type of drive installed or intended to be installed (multi-speed drive or variable speed drive); (e) type of HRS (run-around, other, none); (f) thermal efficiency of heat recovery (in % or ‘not applicable’ if the product has no heat recovery system); (g) nominal NRVU flow rate in m 3 /s; (h) effective electric power input (kW); (i) SFP int in W/(m 3 /s); (j) face velocity in m/s at design flow rate; (k) nominal external pressure (Δp s, ext ) in Pa; (l) internal pressure drop of ventilation components (Δp s,int ) in Pa; (m) optional: internal pressure drop of non-ventilation components (Δp s,add ) in Pa; (n) static efficiency of fans used in accordance with Regulation (EU) No 327/2011; (o) declared maximum external leakage rate (%) of the casing of ventilation units; and declared maximum internal leakage rate (%) of bidirectional ventilation units or carry over (for regenerative heat exchangers only); both measured or calculated according to the pressurisation test method or tracer gas test method at declared system pressure; (p) energy performance, preferably energy classification, of the filters (declared information about the calculated annual energy consumption); (q) description of visual filter warning for NRVUs intended for use with filters, including text pointing out the importance of regular filter changes for performance and energy efficiency of the unit; (r) in the case of NRVUs specified for use indoors, the casing sound power level (L WA ), rounded to the nearest integer; (s) internet address for disassembly instructions as referred to in point 3. 2. The information listed in point 1(a) to (s) shall be available: — in the technical documentation of NRVUs; and — on free access websites of manufacturers, their authorised representatives, and importers. 3. The manufacturer's free access website shall make available detailed instructions, inter alia, identifying the required tools for the manual pre-/dis-assembly of permanent magnet motors, and of electronics parts (printed wiring boards/printed circuit boards and displays > 10 g or > 10 cm 2 ), batteries and larger plastic parts (> 100 g) for the purpose of efficient materials recycling, except for models of which less than 5 units per year are produced.