ANNEX VII附則
ANNEX VII Selective treatment for materials and components of waste electrical and electronic equipment referred to in Article 8(2) 1. As a minimum the following substances, mixtures and components have to be removed from any separately collected WEEE: — polychlorinated biphenyls (PCB) containing capacitors in accordance with Council Directive 96/59/EC of 16 September 1996 on the disposal of polychlorinated biphenyls and polychlorinated terphenyls (PCB/PCT) ( 1 ) , — mercury containing components, such as switches or backlighting lamps, — batteries, — printed circuit boards of mobile phones generally, and of other devices if the surface of the printed circuit board is greater than 10 square centimetres, — toner cartridges, liquid and paste, as well as colour toner, — plastic containing brominated flame retardants, — asbestos waste and components which contain asbestos, — cathode ray tubes, — chlorofluorocarbons (CFC), hydrochlorofluorocarbons (HCFC) or hydrofluorocarbons (HFC), hydrocarbons (HC), — gas discharge lamps, — liquid crystal displays (together with their casing where appropriate) of a surface greater than 100 square centimetres and all those back-lighted with gas discharge lamps, — external electric cables, — components containing refractory ceramic fibres as described in Commission Directive 97/69/EC of 5 December 1997 adapting to technical progress for the 23rd time Council Directive 67/548/EEC on the approximation of the laws, regulations and administrative provisions relating to the classification, packaging and labelling of dangerous substances ( 2 ) , — components containing radioactive substances with the exception of components that are below the exemption thresholds set in Article 3 of and Annex I to Council Directive 96/29/Euratom of 13 May 1996 laying down basic safety standards for the protection of the health of workers and the general public against the dangers arising from ionizing radiation ( 3 ) , — electrolyte capacitors containing substances of concern (height > 25 mm, diameter > 25 mm or proportionately similar volume). These substances, mixtures and components shall be disposed of or recovered in compliance with Directive 2008/98/EC. 2. The following components of WEEE that is separately collected have to be treated as indicated: — cathode ray tubes: the fluorescent coating has to be removed, — equipment containing gases that are ozone depleting or have a global warming potential (GWP) above 15, such as those contained in foams and refrigeration circuits: the gases must be properly extracted and properly treated. Ozone-depleting gases must be treated in accordance with Regulation (EC) No 1005/2009, — gas discharge lamps: the mercury shall be removed. 3. Taking into account environmental considerations and the desirability of preparation for re-use and recycling, points 1 and 2 shall be applied in such a way that environmentally-sound preparation for re-use and recycling of components or whole appliances is not hindered. ( 1 ) OJ L 243, 24.9.1996, p. 31 . ( 2 ) OJ L 343, 13.12.1997, p. 19 . ( 3 ) OJ L 159, 29.6.1996, p. 1 .