ANNEX VSupplementary provisions
ANNEX V VERIFYING EMISSIONS OF CRANKCASE GASES (TYPE 3 TEST) 1. INTRODUCTION 1.1. This Annex describes the procedure for the type 3 test verifying emissions of crankcase gases as described in section 5.3.3. of UN/ECE Regulation No 83. 2. GENERAL REQUIREMENTS 2.1. The general requirements for conducting the type 3 test shall be those set out in sections 1 and 2 of Annex 6 to UN/ECE Regulation No 83, with the exceptions set out in points 2.2 and 2.3 below. 2.2. Reference to the Type I test in paragraph 2.1. of Annex 6 to UN/ECE Regulation No 83 shall be understood as referring to the Type 1 test in Annex XXI to this Regulation. 2.3. The road load coefficients to be used shall be those for VL. If VL low does not exist the VH road load shall be used. 3. TECHNICAL REQUIREMENTS 3.1. The technical requirements shall be those set out in section 3 to 6 of Annex 6 to UN/ECE Regulation No 83, with the exception set out in point 3.2 below. 3.2. References to the Type I test in paragraph 3.2. of Annex 6 to UN/ECE Regulation No 83 shall be understood as referring to the Type 1 test in Annex XXI to this Regulation.