1
Subject to paragraphs 2 to 6, an economic operator who either places or makes available common charger radio equipment on the market must use a label in the following format—
The Radio Equipment Regulations 2017 Schedule 1B — Label in relation to charging capabilities and compatible charging devices.
2
The letters “XX” must be replaced by the figure corresponding to the minimum power required by the radio equipment to charge, which determines the minimum power that a charging device needs to supply to charge the radio equipment.
3
The letters “YY” must be replaced by the figure corresponding to the maximum power required by the radio equipment to achieve maximum charging speed, which determines the power that a charging device needs to supply at least to achieve that maximum charging speed.
4
The abbreviation “ USB PD ” (USB Power Delivery) must be displayed if the radio equipment supports that charging protocol.
5
The label may vary in appearance (for example as to its colour, solid or hollow, line thickness) and, subject to paragraph 6, it may be reduced or enlarged, but in the event of any variation in appearance the label must remain visible and legible.
6
If the label is reduced or enlarged, the proportions set out in the drawing at paragraph 1 of this Schedule must be used. The dimension “a” referred to in the pictogram at paragraph 1 must be greater than or equal to 7 mm, irrespective of any variation in appearance permitted by paragraph 5.
Back to The Radio Equipment Regulations 2017 — full text
Provisions on this page are reproduced verbatim from official open data. See the attribution line.
Contains public sector information licensed under the Open Government Licence v3.0 (legislation.gov.uk).