reg 37 Conformity with other standards and requirements
(1) Where there are no relevant designated standards, electrical equipment which complies with relevant international safety provisions is to be presumed to be in conformity with the principal elements of the safety objectives unless there are reasonable grounds for suspecting that the electrical equipment does not so comply. (2) When there are no relevant designated standards and no relevant international safety provisions, electrical equipment is to be taken to comply with the principal elements of the safety objectives where— (a) the equipment has been manufactured in accordance with the national safety provisions applicable to that equipment in the member State of manufacture; and (b) as a result of its compliance with those national safety provisions, at the time when it is made available on the market it is at least as safe as it would be if it were in conformity with the principal elements of the safety objectives. (3) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .