2005/484/EC: Commission Decision of 4 July 2005 on the procedure for attesting the conformity of construction products pursuant to Article 20(2) of Council Directive 89/106/EEC as regards cold storage building kits and cold storage building envelope kits (notified under document number C(2005) 1961) (Text with EEA relevance)

• CELEX: Directive 89/106/EEC
• Articles: 5

Article 1

The products set out in Annex I shall have their conformity attested by a procedure whereby, in addition to a factory production control system operated by the manufacturer, an approved certification body is involved in assessment and surveillance of the production control or of the product itself.

Article 2

The procedure for attesting conformity as set out in Annex II shall be indicated in the mandates for Guidelines for European technical approvals.

Article 3

This Decision is addressed to the Member States.

Schedules & Appendices

ANNEX I

ANNEX I

Cold storage building kits and cold storage building envelope kits:

—

For use in building works.

ANNEX II

ANNEX II

Note: for products having more than one of the intended uses specified in the following families, the tasks for the approved body, derived from the relevant systems of attestation of conformity, are cumulative.

COLD STORAGE BUILDING KITS AND COLD STORAGE BUILDING ENVELOPE KITS

Systems of attestation of conformity

For the product(s) and intended use(s) listed below, European Organisation for Technical Approval (EOTA) is requested to specify the following system(s) of attestation of conformity in the relevant guideline for European technical approvals:

Product(s)

Intended use(s)

Level(s) or class(es)

(reaction to fire)

Attestation of conformity system(s)

Cold storage building kits and cold storage building envelope kits

In building works

—

1

System 1: see Directive 89/106/EEC, Annex III.2, point (i), without audit-testing of samples.

The specification for the system should be such that it can be implemented even where performance does not need to be determined for a certain characteristic, because at least one Member State has no legal requirement at all for such characteristic (see Article 2(1) of Directive 89/106/EEC and, where applicable, clause 1.2.3 of the Interpretative Document). In those cases the verification of such a characteristic must not be imposed on the manufacturer if he does not wish to declare the performance of the product in that respect.