ANNEX VISupplementary provisions
ANNEX VI Templates for the EU type-approval certificate LIST OF APPENDICES Appendix Number Appendix title Page 1 Model of the EU whole-vehicle type-approval certificate for a complete vehicle type 159 2 Model of the EU whole-vehicle type-approval certificate for an incomplete type, a vehicle type with complete and incomplete variants, a vehicle type with completed and incomplete variants or a completed vehicle type 162 3 Model of the addendum to the EU type-approval certificate 166 4 Model of the EU type-approval certificate for a vehicle system 170 5 Model of the EU type-approval certificate for a separate technical unit or component 172 6 Model of the addendum to the EU type-approval certificate for a separate technical unit or component 174 1. General requirements 1.1. Model A of the EU whole-vehicle type-approval certificate for a complete vehicle type is set out in Appendix 1. 1.2. Model B of the EU whole-vehicle type-approval certificate for an incomplete vehicle type, a vehicle type with complete and incomplete variants, a vehicle type with completed and incomplete variants or a completed vehicle type is set out in Appendix 2. 1.3. The list of applicable requirements or acts to which the type of vehicle complies and which are appended to the EU whole-vehicle type-approval certificate when the manufacturer chooses the single-step type-approval procedure according to Article 30(6) of Regulation (EU) No 168/2013 is set out in Appendix 3. 1.4. Model C of the EU type-approval certificate for a vehicle system is set out in Appendix 4. 1.5. Model D of the EU type-approval certificate for a separate technical unit or component is set out in Appendix 5. 1.5.1. The addendum to the separate technical unit or component type-approval certificate is set out in Appendix 6. When a component/separate technical unit has any restrictions on use, those restrictions shall be verified at the time of vehicle type-approval and indicated in this addendum. This addendum also identifies the separate technical units and components which can be EU type-approved and under which conditions. 1.6. The type-approval certificate shall be no bigger than A4 paper format (210 × 297 mm) or a folder of maximum A4 format.