Sch 3 para 2A Transitional provisions relating to UK withdrawal from the EU
(1) In this regulation— “ pre-exit period ” means the period beginning with the commencement date and ending immediately before IP completion day; (2) Subject to paragraph (3), where a regulated measuring instrument was made available on the market during the pre-exit period, despite the amendments made by Schedule 27 of the Product Safety and Metrology (Amendment etc.) (EU Exit) Regulations 2019, any obligation to which a person was subject under these Regulations as they had effect immediately before IP completion day, continues to have effect as it did immediately before IP completion day, in relation to that regulated measuring instrument. (3) Paragraph (2) does not apply to— (a) any obligation of any competent authority to inform the European Commission or Member States of any matter; or (b) any obligation to take action outside of the United Kingdom in respect of that regulated measuring instrument. (4) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (5) Where paragraph (6) applies to a regulated measuring instrument, regulations 72 and 73 have effect in relation to that instrument, subject to the modifications set out in paragraph (7). (6) This paragraph applies to a regulated measuring instrument that has been placed on the market— (a) during the pre-exit period; or (b) pursuant to Article 41 of the EU withdrawal agreement. (7) The modifications referred to in paragraph (5) are that— (a) the reference in regulation 72(2)(a) to “UK marking” is to be read as a reference to the CE marking within the meaning of Article 4(22) of the Directive; (b) the reference in regulation 72(2)(b) to “M marking” is to be read as a reference to the supplementary metrology marking as described in Article 21(2) of the Directive. (c) the reference in regulation 72(2)(c) to “approved body” is to be read as a reference to the body that undertook the conformity assessment procedure in accordance with Article 17 of the Directive; (d) the references in regulations 72(3)(b) and 73(3)(b) to “type examination certificate” are to be read as references to an “EU-type examination certificate” issued under the conformity assessment procedure set out under the heading “MODULE B: EU-TYPE EXAMINATION” in Annex II to the Directive; and (e) the references in regulations 72(3)(b) and 73(3)(b) to “design examination certificate” are to be read as references to an EU-design examination certificate issued in accordance with the conformity assessment procedure set out under the heading “MODULE H1: CONFORMITY BASED ON FULL QUALITY ASSURANCE PLUS DESIGN EXAMINATION” in Annex II to the Directive. (8) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (9) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .